Featured Products

ELM327 WiFi Interface ELM327 WiFi Interface
$26.99 $29.95
OBD2 Extension Cable OBD2 Extension Cable
$17.99 $19.95

ELM327 WiFi Setup Manual for iPhone

Published on November 19, 2015 by Nick
ELM327 WiFi iPhone Manual

Download and Print the Wi-Fi ELM327 Setup Instruction Manual for iPhone and iPad

  1. Start your vehicle or make sure the ignition switch has power to the battery.
  2. Connect the ELM Interface to your vehicle.
  3. Go to your iPhone or iPad Settings > General > Network > Wi-Fi
  4. Change Settings for the Wi-Fi OBD Network to the following
    • Change the first setting from DHCP to Static.
    • Enter IP Address:
    • Enter Subnet Mask:
    • Change HTTP Proxy to Auto.
  5. Go back to Wi-Fi Networks, Scan for and join the Wi-Fi OBD Network, if it asks for a password enter “12345678”
  6. Open the software application of your choice, DashCommand or to start an inexpensive alternative is RevLite.
  7. In DashCommand go to Settings, Change Auto Connect to On and OBD-II Interface Type to ELM. Go back to the main menu and click Connection to access the ELM327 Hardware and connect to your vehicle. In RevLite go to settings and Set Kiwi Wifi as your hardware and click custom, enter as the IP address and 35000 as the port. The software will detect the hardware and connect to your vehicle.
  8. Trouble codes and real-time data should now be available to you.


No comments have been posted yet.

Post Comment

Subscribe All Comments Replies None
Verification5 + 2 - 3 =

Link To Directory
RSS Feeds
© 2024 Interfuse LLC. All Rights Reserved.